• KR Pixel Stick

click on thumbnail to zoom
Item #: KRPIXST
Our Price: $84.99
Quantity:
 
Stock available

Description 

KR Pixel Sticks alleviate the need for peeling and sticking strips together. These strips are a 34.65" long rigid PCB with carefully sourced LED's on both sides that are staggered. This provides Maximum LED Coverage and is better than the typical 144 LEDs per meter.

The stick is designed with bigger solder pads for improved efficiency, rounded ends for easier foam installs, and pre-installed Data line resistors.

Please be aware

1. These are not meant for dueling

2. We do not recommend these to be trimmed and if you are looking for custom lengths, please use the flexible strips.

3. If you are using a CFX or NB you must define the amount of LED pixels at 264.

4. For 1" thin walled tubes order the stick specific foam. 

We have found in our testing that 34.5" long tubes combined with a Parabolic Pixel tip worked the best with these strips. This is not a guarantee due various variables such as wire length etc. Your mileage may vary. 

1" Thin, 1" Thick, and 7/8" Thin walled Transluscent White and Photon tubes can now be purchased at 34.5" . 

Reviews

Average Rating:
(based on 2 reviews)

Showing 2 Reviews:

RatingReviewerReview
by Kevin
on 9/12/2020
from Hagerstown
15 minute blade
I had a blade ready to go within 15 minutes of unpacking. Its significantly less headache than I was looking forward too with DIY pixel blades
by Nalyd
on 8/20/2020
from SF., CA
Easy, quick, and BRIGHT!
Bought this for my first Neopixel build and I was not disappointed. It's super easy to solder up, and once you remember to set your pixels to 264 on your soundcard, it works brilliantly. I built a thin-wall blade and as mentioned, it does rattle a bit in the tube since the foam has an OD that's too small for the thin-wall blade. A thick-wall blade shouldn't have that problem. Definitely recommend!
Review and Rate this Item

What's New