Screw on LED blade holder for screw together hilt system.
2.5" long with 2" unthreaded.
Designed to hold 1" blades.
These do not come pre-drilled for a blade retention screw. We do offer a service to add one in the services section.
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
2.5" long with 2" unthreaded.
Designed to hold 1" blades.
These do not come pre-drilled for a blade retention screw. We do offer a service to add one in the services section.
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
1.45" OD
2" long (not including male threaded section)
Holds a 1" blade
2" long (not including male threaded section)
Holds a 1" blade
Good little emitter
The inside is a little tight, so I couldn't fit certain blades without modifying the inside via sanding. I don't suggest putting the blade retention screw in the center because that is the thinnest part of the emitter, it is easy to over tighten and potentially strip.