Adds 2" to length of hilt. Tapers down from 1.45" to 1" and then back out to 1.45".
Has 6 1/8" holes on each angled side which are perpendicular to the angled face.
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
Has 6 1/8" holes on each angled side which are perpendicular to the angled face.
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
Short choke with holes
I'm doing a custom black chrome and copper hilt for my step son's Christmas present with brass custom dual tactile switches and I must say that this choke in copper with the holes has allowed me a very unique customization possibility that will blow his socks off theses are great lightweight pieces I'm going to get a lot more in the future thank you tcss
Unlimited uses
As always TCSS quality is above reproach. If you use the flat style heat sink light will shine through the holes. Of course the top will have more light than the bottom. But it's a cool look. Of course you could put an accent LED or run wires through it or fiber optics. The sky is the limit. It would be really sick above a crystal chamber.