Two-piece screw on LED blade holder for MHSv1
This has 2x 10-32 holes, 1x 8-32 hole, 2x 4-40 threaded holdes for bunny ears, and the 4 small holes threaded for the graflex electrical pins. The ribbed portion utilizes MHSv2 threads to thread in to the top portion of the emitter.
Includes 3x 4-40 set screws (preinstalled in the ribbed section threads) to hold a 1" blade adapter or heatsink. Does not work with MHS Heatsinks.
Adds 5.75" to length of saber.
Designed to hold 1" blades.
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
This has 2x 10-32 holes, 1x 8-32 hole, 2x 4-40 threaded holdes for bunny ears, and the 4 small holes threaded for the graflex electrical pins. The ribbed portion utilizes MHSv2 threads to thread in to the top portion of the emitter.
Includes 3x 4-40 set screws (preinstalled in the ribbed section threads) to hold a 1" blade adapter or heatsink. Does not work with MHS Heatsinks.
Adds 5.75" to length of saber.
Designed to hold 1" blades.
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
You can be the first one to write a review.
