Double threaded hilt for Modular Hilt System. Both ends have female threads. Little under 1.5" OD with a overall length of 7".
You can select to have no switch hole or a Standard, Guarded, AV, or Recessed AV switch hole which will be machined 1.5" from the non grooved end. If you would like the hole in a different location then please order it without a switch hole and order the switch hole service instead so you can specify the location.
We can align the switch hole with other parts as long as you specify the order of all the parts and all parts are ordered at the same time including the heat sink.
All MHS parts should have the threads wiped clean and then lightly oiled or greased.We sell some
Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
We do not recommend using the switch hole near the pommel as the last groove closest to the opposite end is over the inner threading and can break if it is subjected to hard forces.