3.5" Double ended female threaded connector. Works with all male threaded MHS parts. Has cutouts for a Graflex Clamp and includes a predrilled 8-32 hole with an included Knurled cone. Graflex Clamp is not included.
Has a 1.5" and 1.58" OD
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
Has a 1.5" and 1.58" OD
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
V2 Enthusiasts (And More) REJOICE!
For a while now, I've been obsessed with one thing; Luke Skywalker's "unofficial" hero lightsaber from Return of the Jedi, the "V2." I've spent so much time looking around for various parts and pieces to a V2 with parts to match my modular chassis that uses MHSV1 parts, and here TCSS has solved two of the biggest challenges in a single piece!!! The graflex adapter with the little bit that shows above the clamp? *Chefs kiss* The diameter of the portion below the clamp? *chefs kiss!* The INCLUDED knurled cone knob??? *A THOUSAND KISSES* I ordered this as soon as it went up because this combined with the recent MTN parts means an accurate V2 is achievable, comfortable, and modular! Possibilities with this piece becoming the basis for a prequel obi saber also abound! My only recommendation to others would be to slightly sand the cone knob bit. Very point and a tad sharp, just needs a little tlc to not poke you