MWS BuckPuck
Input voltage must be greater than 5v and below 32v
Supports the following components via screw terminals with JST connectors pre-installed.
- Blue- and White+ JST > Main LED (L+ and L-)
- Red and Black JST > Accent LED (A+ and A-) Only on when switch is on
- Yellow JST > Latching Switch (SW)
- Accent LED Resistor (ARES) Simply attach one of the resistor legs to each of the terminals. This will reduce the output voltage to the Accent LED terminals.
- Red and Black JST > Recharge Port (R+ and R-) This simply goes straight to the battery. Only charge with switch turned off.
- Red and Black JST > Battery Input (B+ and B-)
Make sure the bottom is either placed in a safe location or covered so the pins cannot create a short circuit. This can be done by simply taping over them.