Adds 2.5" to length of hilt. Tapers down from 1.45" to 1" and then back out to 1.45".
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
A nice choke but a small disapointment
I love the feel and ergonimics of this part especially paired with BH 24, however... I was hoping the blade could fit down inside, it does not. I think the OD and ID could have been made just a bit wider to accomodate a blade. However, I do relly enjoy this part, my hand fits around it perfectly and it is great for twirls and fast swings.
Excellent
Exactly what the others have said, this piece is perfect for spinning, great if you do alot of fancy spins in choreography or sparing.
Perfect!
Its strong, stylish and adds that final bit of sweetness to your saber! Its very good just behind the blade holder, especially for Anakins 360 spin! A must have for sabers!
review
found out on the slightly tight fit of the heatsink, a simple solution was to use a dremel and take just a lil off the outside edge of heatsink, and it will then fit perfectly in the neck section. did this to mine, and it was perfect.
MHS Choke Point
This is a very nice addition to the shop, and any saber as well. It's a very strong piece with enough room inside to allow passage for wires. I would recommend a quick connect kit for you LED when using this part. I find that this part also increased my saber spinning effeciency.