MHSV1 Blade Holder Style 16

(9)
Price: $31.99
  • SKUholder16

Include Heat Sink?

Stock available
- +
Screw on LED blade holder for screw together hilt system.

Adds 2" to length of saber and has 1.9" max OD.

Designed to hold 1" blades.

These do not come pre-drilled for a blade retention screw. We do offer a service to add one in the services section.

All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
Adds 2" to length of saber
OD at base 1.45"
OD at steps from base 1.2", 1.6", and 1.9" max OD
(9)
Average rating 10 out of 10 ( based on 9 reviews )

Beautiful emitter!

Review by Jordan on 3/20/2024

This piece is gorgeous and compliments my hilt well, there is even a groove milled on the inside of the emitter to allow light to shine through the holes on the top. Threads were nice and smooth and the piece had a nice finish with no blemishes. 10/10!

It really ties the saber together

Review by Dan on 7/15/2020

As always the quality is above reproach. Out of the 10+ different blade holders that I have purchased this is my favorite.The pitchers don't do it justice. Light does shine through the holes. Defiantly check it out on the 3D MHS Builder. You will not be disappointed.

Beautiful design and engineering

Review by Lee on 8/27/2015

Looks great, light, and well mode. The heat sink (v3) and lens holder integrates elegantly.

Real nice

Review by Mike C on 6/9/2014

Excellent work as always - classic look.

Impressive Most Impressive!

Review by JEDI ERIN on 12/27/2012

My favorite blade holder yet. The detail is more than the I expected. The BH I received has a small groove on the inside that allows the light to show through the tiny holes around the emmiter(not shown in photo above). I had no trouble w/ the blade fitting,it was very impressive to say the least. great job Tim!

Write a Review